HiPath1120, Installation Guide
3-27
Installation
Installing modules
3.7.10 Installing a Music module
Installation Procedures
Assembly Diagram
Figure 3-12 Installing a Music module HiPath 1120
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Raise the system’s top slot (MB).
4. Insert the module in the slot shown on figure 3-12.
5. Attach the MB to the module.
6. Make the connections to the appropriate module Connector.
7. Reassemble the entire set.
8. “Performing a visual inspection” on page 3-35.
9. Turn on the power supply.
10. Configure the required data (see Service Manual).
To Next Page
Loading...
