Putting the handset into service
16
Putting the handset into service
Removing the protective cover
Inserting the battery pack
The handset is supplied with the approved battery pack. The battery pack
is not loaded. It is first charged in the handset.
1. Removing the attachment clip (if installed)
Insert a screwdriver between the attachment clip and the battery cover (1)
and force the attachment clip outward (2) until it dislodges.
Remove the protective cover from the display before
putting the handset into service.
Note:
• Note: Please observe the safety notes on the back cover.
• Only use the approved battery pack (Æ Page 19).
• Open the battery compartment in a dust-free environment only.
• Your telephone directory entries and all settings remain stored
even if you remove the battery pack. The date and time settings
will be reset.
• Only remove the battery pack if it is defective. The battery
pack’s life diminishes each time it is removed.
2
1
To Next Page
Loading...
Need help?
General