Mounting and connecting the device
4.1 Mounting the device
LOGO! CIM
26 Operating Manual, 10/2021, A5E51250518-AA
4.1.3 Wall-mounting
Wall-mounting
To mount the CIM on a wall, follow the steps below:
1. Using a screwdriver, pull the two mounting slides ① on the rear of the device towards the
outside.
2. Feed the screws through the openings in the catches and secure the device to the wall.
Note
When you do not wall
-mount LOGO! CIM, always keep the mounting slides in the factory
lt positions, that is, within the data area given in the illustration above; otherwise, the
mounting slides may deform if they are exposed to hot and humid surroundings for a long
term.
To Next Page
Loading...
