Mounting and connecting the device
4.3 Installing expansion modules
LOGO! CIM
34 Operating Manual, 10/2021, A5E51250518-AA
3. Install the SMA connector as the marked order into the hole.
4. Install the middle housing back on the bottom housing. When install the middle housing,
place the bottom of the SMA connectors below the top PCBA first, then adjust the position
of the middle housing and install it back.
4.3.3 Insert the SIM card
Requirement
• The device is disconnected from the power supply and the DIAG LED goes out.
• The SIM card is suitable for industrial use.
Compatible cards: Mini SIM card, 25 x 15 mm (ISO/IEC 7810 ID-000)
Install the SIM card
Inserting a SIM card
If you are using the SIM card in a device installed in a system, you must observe the safety
regulations for work on electrical systems.
Carefully insert the SIM card into the card holder without applying excess force.
To Next Page
Loading...
