Application and functions
LOGO! CIM
Operating Manual, 10/2021, A5E51250518-AA
7
General gateway
LOGO! CIM can access the Internet with cellular module and SIM card installed. LOGO! BM or
Modbus RTU compatible devices can access the internet by connecting to LOGO! CIM.
Further functions
The CIM supports the following functions:
• Web-based configuration
A Web-based user interface (Web-based configuration) for the configuration of the CIM.
• Protocol gateway
LOGO! BM and Modbus RTU compatible devices can communicate with LOGO! CIM via
S7/Modbus protocol based on the Universal Data Model (UDM).
Application can access data through RESTful API on LOGO! CIM based on UDM.
• Data management
CIM can perform an action when a configured event is triggered.
– After configured, LOGO! CIM can perform an action, for example, change the data in
UDM, send one or more short messages to one or more contacts.
• Mobile cellular
With the CIM, you can establish a mobile data connection to a mobile cellular network.
• GNSS position
– Display the position information on the web page
– Enable/disable map the position data to UDM
• Time Server
– LOGO! CIM can act as an NTP server to provide time for LOGO! BM or other NTP client.
– LOGO! CIM can enable/disable mapping the time to the Universal Data Model (UDM).
Then the device without NTP can get the time via multi-protocol or RESTful API.
• Power on/off SMS
– CIM can send a power on/off SMS to one defined contact.
Web-based configuration
You can configure the CIM locally using a web-based configuration that can be displayed with
a Web browser. The web-based configuration provides the following functions:
• Configure the LAN of CIM
• Manage the contacts
• Configure variables, messages and data bindings
• Configure the multi-protocol
• Configure the cellular module
• Set the system time and synchronization of the CIM
To Next Page
Loading...
