SITRANS F M
6. Installation of transmitter
47
1. Use a screwdriver to remove the outer
frame.
2. Loosen the 4 screws retaining the control
pad.
3. Withdraw the control pad and turn it to the
required orientation.
4. Tighten the 4 screws until a mechanical
stop is felt in order to obtain IP 67 enclo-
sure rating.
5. Snap-lock the outer frame onto the control
pad (click).
The transmitter can be mounted in either
direction as the arrow indicates without turning
the terminal box.
The connection board needs to be oriented
according to the display direction.
The terminal box can be rotated ±90° in order
to optimize the viewing angle of the transmitter
display/keypad:
1. Unscrew the four screws in bottom of
terminal box.
2. Turn terminal box to required position.
3. Retighten screws firmly
Turning the control pad
Turning the transmitter
1
2
4
3
5
To Next Page
Loading...
