Siemens MAG 5100 W - Installation in IP 65 Panel Mounting Enclosure (Front of Panel)

54
SITRANS F M
6. Installation of transmitter
6.2.7
Installation in IP 65 panel
mounting enclosure
(front of panel)
1. Mount the SENSORPROM
®
memory unit on the connection board as shown.
The SENSORPROM
®
unit is supplied with the sensor in the terminal box.
2. Fit the enclosure in a cut out at the front of a panel. Fasten the four screws accessible at the
front.
3. Connect the cables as shown under "Electrical connection", chapter 7.
4. Insert the transmitter and close the cover.