Siemens micromaster 410 - Page 53

Issue 04/02 5 System Parameters
MICROMASTER 410 Operating Instructions
6SE6400-5EA00-0BP0
53
Analogue I/O (P0004 = 8)
ParNr ParText Default Acc DS QC
r0752 Act. input of ADC [V] - 3 - -
P0753 Smooth time ADC 3 3 CUT N
r0754 Act. ADC value after scaling [%] - 2 - -
P0757 Value x1 of ADC scaling [V] 0 3 CUT N
P0758 Value y1 of ADC scaling 0.0 3 CUT N
P0759 Value x2 of ADC scaling [V] 24 3 CUT N
P0760 Value y2 of ADC scaling 100.0 3 CUT N
P0761 Width of ADC deadband [V] 0 3 CUT N
Setpoint Channel and Ramp Generator (P0004 = 10)
ParNr ParText Default Acc DS QC
P1000 Selection of frequency setpoint 2 1 CT Q
P1001 Fixed frequency 1 0.00 2 CUT N
P1002 Fixed frequency 2 5.00 2 CUT N
P1003 Fixed frequency 3 10.00 2 CUT N
r1024 CO: Act. Fixed frequency - 3 - -
P1031 Setpoint memory of the MOP 0 2 CUT N
P1032 Inhibit reverse direction of MOP 1 3 CT N
P1040 Setpoint of the MOP 5.00 3 CUT N
P1070 CI: Main setpoint 755:0 3 CT N
P1071 CI: Main setpoint scaling 1:0 3 CT N
P1075 CI: Additional setpoint 0:0 3 CT N
r1078 CO: Total frequency setpoint - 3 - -
P1080 Min. frequency 0.00 1 CUT Q
P1082 Max. frequency 50.00 1 CT Q
P1091 Skip frequency 1 0.00 3 CUT N
P1120 Ramp-up time 10.00 1 CUT Q
P1121 Ramp-down time 10.00 1 CUT Q
P1130 Ramp-up initial rounding time 0.00 3 CUT N
P1131 Ramp-up final rounding time 0.00 3 CUT N
P1132 Ramp-down initial rounding time 0.00 3 CUT N
P1133 Ramp-down final rounding time 0.00 3 CUT N
P1134 Rounding type 0 3 CUT N
P1135 OFF3 ramp-down time 5.00 3 CUT Q
r1170 CO: Frequency setpoint after RFG - 3 - -