Siemens micromaster 410 - Page 55

Issue 04/02 5 System Parameters
MICROMASTER 410 Operating Instructions
6SE6400-5EA00-0BP0
55
Communication (P0004 = 20)
ParNr ParText Default Acc DS QC
P0927 Parameter changeable via 15 3 CUT N
r0964[5] Firmware version data - 3 - -
P0971 Transfer data from RAM to EEPROM 0 3 CUT N
P2000 Reference frequency 50.00 3 CT N
P2009[2] USS normalization 0 3 CT N
P2010[2] USS baudrate 6 3 CUT N
P2011[2] USS address 0 3 CUT N
P2012[2] USS PZD length 2 3 CUT N
P2013[2] USS PKW length 127 3 CUT N
P2014[2] USS telegram off time 0 3 CT N
r2015[4] CO: PZD from BOP link (USS) - 3 - -
P2016[4] CI: PZD to BOP link (USS) 52:0 3 CT N
r2018[4] CO: PZD from COM link (USS) - 3 - -
P2019[4] CI: PZD to COM link (USS) 52:0 3 CT N
r2024[2] USS error-free telegrams - 3 - -
r2025[2] USS rejected telegrams - 3 - -
r2026[2] USS character frame error - 3 - -
r2027[2] USS overrun error - 3 - -
r2028[2] USS parity error - 3 - -
r2029[2] USS start not identified - 3 - -
r2030[2] USS BCC error - 3 - -
r2032 BO: CtrlWrd1 from BOP link (USS) - 3 - -
r2031[2] USS length error - 3 - -
r2033 BO: CtrlWrd2 from BOP link (USS) - 3 - -
r2036 BO: CtrlWrd1 from COM link (USS) - 3 - -
r2037 BO: CtrlWrd2 from COM link (USS) - 3 - -
Alarms, Faults and Monitoring (P0004 = 21)
ParNr ParText Default Acc DS QC
P0952 Total number of faults 0 3 CT N
r0947[8] Last fault code - 2 - -
r2110[4] Warning number - 3 - -
r2114[2] Run time counter - 3 - -
P2167 Switch-off frequency f_off 1.00 3 CUT N