Step by Step
Using Other Functions
72
• Lea ve a n advis ory message,
code:
*
69/#69 Æ page 65
• Group ringing , code:
*
81/#81 Æ page 85
• Group call, code:
*
85/#85 Æ page 85
• Suppress caller ID,
code:
*
86/#86 Æ page 26
• Waiting tone, code:
*
87/#87 Æ page15
• Open door, code:
*
61 Æ page 21
• Door opener on/off, code:
*
89/#89 Æ page 22
• Control relay, code:
*
90/#90 Æ page 75
• Do not disturb, code:
*
97/#97 Æ page 19
• Ringer cutoff function, code:
*
98/#98 Æ page 19
• Speed-dialing, code:
*
7 Æ page 41
• Associated serv ice, code:
*
83 Æ page 70
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
Set up a call to the system. Enter the station number
(cont act System Support).
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
Enter the code (necessary only if programmed in the
system).
Wait for a dial tone and then enter the code, such as
*
97 for Do not disturb on. Make other inputs as neces-
sary; (refer to the operating instructions for pulse and
DTMF telephones).
or
Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the con-
nection is released as soon as either of the par-
ties ends the call.
To Next Page
Loading...
