Siemens RDS110 - Page 35

Operating the thermostat on the device
Advanced settings
6
A6V10877569_en--_e 35 | 59
No. Application
settings
Descriptions Factory
settings
Range Dependencies
38. Heating
control loop
Indicates a different
time for PWM (Pulse
Width Modulation)
pulse periods. You
can select the default
setting to let the
system configure the
most suitable heating
controller settings
based on your
selected equipment
type.
Default Slow
Medium
Default
Fast
2-position
Self-
adaptive
N/A
39. Floor
temperature
limit
Floor temperature
limit for electric floor
heating
40 °C 35…60 °C Valid only if
you’ve
selected the
equipment type
as “Electric
floor heating”
and enabled
the floor
temperature
input in
Changing
system setup
[➙ 36].
40. Optimum
start control
Pre-heats the room in
an optimum way so
that you can get the
scheduled
temperature setpoint
at your scheduled
occupied time. You
can choose “Warm-
up gradient” to
manually define the
warm-up speed, or
choose “Self-
adaptive” to let the
thermostat learn and
decide the warm-up
speed.
Warm-up
gradient
Warm-up
gradient
Self-
adaptive
Visible only if
you’ve
activated the
optimum start
control settings
in Changing
system setup
[➙ 36].
41. Warm-up
gradient
The warm-up speed
that you set to pre-
heat the room.
30 min/K 0…
120 min/K
Valid only if
you’ve
activated the
optimum start
control settings
in Changing
system setup
[➙ 36] and
selected
“Warm-up
gradient” for
Application
setting No.40