Siemens RDS110 User Manual

Operating the thermostat on the device
Advanced settings
6
38 | 59 A6V10877569_en--_e
– Enable presence detection related functions no matter whether it is the
external or the built-in presence detection sensor detects that someone is
in the room.
● If you’ve configured the equipment type as “Electric floor heating”, choose to
activate or deactivate the floor temperature input.
● Configure the output as a humidifier free-standing, a dehumidifier free-standing
or a domestic hot water boiler.
● Activate or deactivate the optimum start settings for heating. Activating the
optimum start settings allows unoccupied space (a scheduled “Unoccupied”
mode is running) to be pre-heated so that you can get the scheduled
temperature setpoint at your scheduled occupied time (the thermostat enters
into “Comfort” mode).
*) If you’ve selected 0…10 V as the signal type, you must connect a DC 0..10 V
active sensor with the thermostat. Otherwise, the calculated value may not be
accurate.
Change extended configurations
1. On the “Advanced Settings” page, tap .
2. If prompted, enter the administrator password.
3. Tap > .
4. Tap “OK” to stop all the thermostat’s applications. The thermostat restarts.
5. After the restart is completed, tap “I/O” > “Adapt”.
6. Change the settings as desired.

Siemens RDS110 Specifications

General

Interface	WLAN
Control type	Sensor
Product color	Black
Memory function	-
Housing material	Acrylic glass
Smart thermostat	Yes
Quantity	1

Weight and Dimensions

Depth	26 mm
Width	91 mm