RF180C communication module
Operating Instructions, 12/2012, J31069-D0177-U001-A6-7618
5
Introduction
1
Purpose of these operating instructions
The information provided in these Operating Instructions enables you to operate the RF180C
communication module on a PROFINET IO controller.
Basic knowledge required
These operating instructions assume general knowledge of automation engineering and
identification systems.
Scope of the manual
The operating instructions apply to the RF180C communication module.
Position in the information landscape
● In addition to these operating instructions, you require the operating instructions for the
controller used.
● If you are using a SIMATIC S7, you will find information on programming the module as
well as a complete error description in the description of the function blocks FB 45, FB 55
and the RFID standard profile.
● The manual of the relevant RFID family contains information on the readers to be
connected.
● Special information on setting parameters for the RF620R/RF630R readers in conjunction
with the RF180C communications module can be found in the "Configuration manual
RF620R/RF630R (http://support.automation.siemens.
com/WW/view/en/33287195)".
To Next Page
Loading...
Need help?
General
