Installation
3.3 Mounting the connection block
RF180C communication module
Operating Instructions, 12/2012, J31069-D0177-U001-A6-7618
13
Procedure
Fix the base unit onto a level surface using the screws. The base unit must be screwed to
the surface (3 Nm tightening torque) at both fixing points (front, top and bottom).
;
;
[
*7-'
6,0$7,&5)&
Figure 3-1 Mounting the I/O module
3.3 Mounting the connection block
Features
The connection block connects the RF180C with the PROFINET IO and supplies the base
unit with voltage.
Requirements
The base unit is already mounted
To Next Page
Loading...
Need help?
General
