Description
RF180C communication module
8 Operating Instructions, 12/2012, J31069-D0177-U001-A6-7618
● MV400 code readers
● RFID standard profile
● RF300 Filehandler
You will find further information on the various RFID and code readers on the Internet on the
"Product Support (http://support.automation.siemens.com/WW/view/en/43532183
)" page.
Features
Up to two readers can be operated on the RF180C at the same time. You can send a
command to 2 readers simultaneously (FB 45/FB 55 or RFID standard profile when
operating on a SIMATIC S7).
The transponder data is accessed using the physical addressing of the transponder. In
SIMATIC S7, FB 45/FB 55 or RFID standard profile are available for this purpose. FB 45 /
FB 55 / file handle mode provides you with a simple-to-use interface with extensive
commands (processing one complete transponder with one command; command linking; S7
data structures via UDTs).
Other features
● Degree of protection IP67
● System integration with M12, 7/8" concept or with push-pull concept
● Standardized PROFINET IO user interface for identification technology with RFID
standard profile
● Firmware update
● Parameterizable device-specific diagnostics data
● Support of I&M functionality
A mechanism for reading out information via the module and saving system information
such as function, installation date, installation location, and comments. The RF180C
supports I&M data 0, 1, 2 and 3.
● Routing capability
● IRT Flex
● Topology capability
● LLDP protocol
Note
IRT Top and MRP are not supported by today's valid version of the RF180C.
To Next Page
Loading...
Need help?
General
