Siemens RUGGEDCOM RSG2488 Installation Manual

Installing the Device
2.5.3Grounding the Device
1. Connect the positive wire from the power source to the positive terminal on the
terminal block.
2
4
1
6
3
5
4
5
6
3 7
7
7
7
1
Screw-Type Terminal Block for 24 and 48 Power Supply
2
Pluggable Terminal Block for 24P and 48P Power Supply
3
Positive Terminal for PS1
4
Negative Terminal for PS1
5
Positive Terminal for PS2
6
Negative Terminal for PS2
7
Chassis Ground
Figure2.7 DC Terminal Block Wiring
2. Connect the negative wire from the power source to the negative terminal on
the terminal block.
3. Connect the ground terminal on the power source to the ground terminal on the
device. For more information, refer to "Grounding the Device (Page 16)".
2.5.3 Grounding the Device
The RUGGEDCOM RSG2488 chassis ground terminal uses an M3 screw. It is
recommended to terminate the ground connection with an M3 ring or spade lug and
torque it to 1.7 N·m (15 lbf-in).
3
1
2
1
M3 Screw
2
Standoff
16
RUGGEDCOM RSG2488
Installation Manual, 07/2021, C79000-G8976-1048-11

Siemens RUGGEDCOM RSG2488 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RSG2488
Category	Switch
Language	English