C
harging lock active
Forced, max stor tank temp
Forced, max charging temp
Forced, legionella setpoint
Forced, nominal setpoint
Forced charging active
Charging electric, leg setpoint
Charging electric, nominal setpoint
Charging electric, Red setpoint
Charging electric, frost setpoint
El imm heater released
Charging el im heater
Push, leg setpoint
Push, nominal setpoint
Push active
Charging, leg setpoint
Charging, nominal setpoint
Ladung, Reduziertsollwert
Charging active
Frost protection active Frost protection active
Overrun active Overrun active
Standby charging Standby charging
Charged, max stor temp
Charged, max charg temp
Forced, legio temp
Charged, nominal temp
Forced, Reduced temp
Charged
Off. Off.
Ready Ready
Enduser (info level) Commissioning, heating engineer
Dewpoint monitor active Dewpoint monitor active
Manual control active Manual control active
Fault Fault
Frost protection flow active
Frost protection active
Locked, heating mode
Locking period at end of heating
Sperre Erzeuger
Locked, buffer
Cooling mode locked
Flow setpt increase hygro
Min. flow limit, dewpoint
Min. flow limit, outside temp
Cooling mode, restricted
Cooling mode, Comfort
Overrun active
Cooling mode, Comfort
Protection mode, cooling Protection mode, cooling
Frost protection plant active
Frost protection active
Cooling limit OT active Cooling limit OT active
Off.
Room temp lim
Flow limit reached
Off.
Cooling mode off Cooling mode off
State cooling circuit
Enduser (info level) Commissioning, heating engineer
Emergency operation Emergency operation
Fault Fault
Locked, outside temperature
Locked, externally
Locked, economy mode
Locked
3-ph curr asymmetrical
Low-pressure
Fan overload
Compressor 1 overload
Compressor 2 overload
Source pump overload
Flow switch consumers
Limit OT min
State heat pu
mp
214/258
Siemens Switzerland Ltd User manual RVS61.843, RVS41.813 CE1U2355en_02
HVAC Products 6 The settings in detail 28. September 2009
To Next Page
Loading...
