Siemens RVS41.813 - 6.28 Diagnostics Consumers; Outside Temperature; Room

Display of the temperature difference between collector sensor B6 / B61 and buffer
storage tank sensors B4 and B41.
dT collector 1, 2 / buffer
Display of the temperature difference between collector sensor B6 / B61 and swimming
pool sensor B13.
dT collector 1, 2/
s
wimming pool
Display of the
solar flow temperature acquired by sensor B63.
Solar flo
w temp
Display of the
solar return temperature acquired by sensor B64.
S
olar return temp
24-hour yield solar energy
Display of the
amount of energy supplied to the plant via the solar collector in the
course of the day.
Total yield sol
ar energy
Display of the
total of all 24-hour solar yields since the controller was reset last.
Hours run sol
ar yield
Display of the
number of hours the solar plant produced energy (operating hours).
Shows the number of hours during which collector overtemperature protection was
active.
Hours run coll
ect
overtemp
6.28 Diagnostics consumers
For diagnostic purposes, the various setpoints, actual values, relay switching states
and meter readings can be displayed.
Outside temperature
Line no. Operating line
8700 Outside temperature
8701 Outside temp min
8702 Outside temp max
8703 Outside temp attenuated
8704 Outside temperature composite
Display of the actual, minimum, maximum, attenuated and composite outside
temperature. The attenuated outside temperature can be reset directly on operating line
8703 (reset) .
Room
Line no. Operating line
8720 Relative room humidity
8721 Room temperature
8722 Dewpoint temp 1
221/258
Siemens Switzerland Ltd User manual RVS61.843, RVS41.813 CE1U2355en_02
HVAC Products 6 The settings in detail 28. September 2009