Display of 0 V means that there is no voltage and the respective input is currently
inactive. Display of 230 V means that voltage is present at the respective input so that it
is activated.
6.25 State of plant
The current operating state of the plant is visualized by means of status displays.
Messages
Line no. Operating line
8000 State heating circuit 1
8001 State heating circuit 2
8002 State heating circuit P
8003 State DHW
8004 State cooling circuit 1
8006 State heat pump
8007 State solar
8010 State buffer
8011 State swimming pool
8022 State supplementary source
Only RVS41..
Enduser (info level) Commissioning, heating engineer
Limit thermostat has cut out Limit thermostat has cut out
Manual control active Manual control active
Floor curing function active Floor curing function active
Overtemp protection active
Restricted, boiler protection
Restricted, DHW priority
Restricted, buffer priority
Heating mode restricted
Forced discharging buffer storage tank
Forced discharging DHW
Forced discharging heat source
Forced discharging
Overrun active
Forced discharging
Opt start control + boost heating
Optimum start control
Boost heating
Heating mode Comfort Heating mode Comfort
Optimum stop control
Heating mode Reduced Heating mode Reduced
Frost protection room active
Frost protection flow active
Frost protection plant active
Frost protection active
Summer operation Summer operation
24-hour Eco active
Setback Reduced
Setback frost protection
Room temp lim
Off. Off.
State heating circuit
Enduser (info level) Commissioning, heating engineer
Limit thermostat has cut out Limit thermostat has cut out
Manual control active Manual control active
Draw-off mode Draw-off mode
Recooling via collector
Recooling via DHW/HCs
Recooling active
Discharging protection active
Charging time limitation active
DHW charging locked
State DHW
213/258
Siemens Switzerland Ltd User manual RVS61.843, RVS41.813 CE1U2355en_02
HVAC Products 6 The settings in detail 28. September 2009
To Next Page
Loading...
