6.9 Replacing a CLP
To use the CLP correctly, note the structure of the CLP:
① Square edges
② Front edge of the CLP
③ Round edges
Removing a CLP
To remove a CLP from the device, follow the steps below:
1. Turn o the power to the device.
2. To release the CLP, insert a screwdriver between the front edge of the CLP ② and the slot.
3. Remove the CLP from the slot.
Inserting the CLP
To insert a CLP into the device, follow the steps below:
1. Turn o the power to the device.
2. The CLP housing has two square ① and two round ③ edges. Accordingly, the slot opening
has two square and two round edges. Note this orientation when inserting the CLP.
Insert the CLP in the correct orientation into the slot.
Connecting up
6.9 Replacing a CLP
SCALANCE XRH-300/XRM-300
74 Equipment Manual, 10/2022, C79000-G8976-C546-01
To Next Page
Loading...
