Installing/mounting
6.3 Locking devices
3VL IEC molded case circuit breakers
84 System Manual, 11/2013, 110 0110 - 02 DS 03
Locking devices for a padlock
Locking device for the toggle lever
Figure 6-5 Locking device for the toggle lever
The locking device for the toggle lever is designed to be easily attached to the molded case
circuit breaker escutcheon. This device allows the lever to be locked in the "OFF" position.
The locking device for the toggle lever can be installed in 3-pole and 4-pole molded case
circuit breakers. Up to 3 padlocks with diameters from 5 to 8 mm may be used. (Not for the
VL160X with RCD module)
Locking device for front-operated rotary operating mechanism
Figure 6-6 Locking device for front-operated rotary operating mechanism
To Next Page
Loading...
