EasyManua.ls Logo

Siemens SENTRON 3WL10 - TD310 Activation & Trip Box; TD410 Breaker Data Adapter

Siemens SENTRON 3WL10
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The powerservice software can be found in the SIOS Portal (https://
support.industry.siemens.com/cs/ww/en/view/109749079).
Note
On the circuit breaker, the connection from the ETU to the trip coil and its ability to function can
only be electromechanically tested after a fault, maintenance, or modi󹪝cation of the device. The
electronics of the instrument transformers via ETU to the trip coils are continuously monitored
during operation to ensure the greatest safety and faults are handled immediately (tripping or
only alarm).
3.6.2 TD310 Activation & Trip Box
The TD310 Activation & Trip Box is connected to the front test plug of the ETU. It can be used with
all electronic trip units of the 3- and 6-series.
Function scope:
Activation of the electronic trip units of the 3- and 6-series with a battery built into the test
device
Testing the release and the trip coil of the circuit breaker for correct functioning (trip test)
By activation via the TD310 Activation & Trip Box, the electronic trip units of the 6-series can
be parameterized on the display, even when the circuit breaker is switched o󹪜.
Note
With or without an external power supply, the reasons for the last trip are always displayed on
the LEDs (ETUs of the 3‑series) or on the display (ETUs of the 6‑series) when the control key "i /
Test" is pressed. To enable this display, the ETU has a battery.
3.6.3 TD410 Breaker Data Adapter
The TD410 Breaker Data Adapter is a gateway and is connected on one side with the USB port of
a PC and on the other side to the ETU of the circuit breaker via the cable supplied. It can be used
with all electronic trip units of the 3- and 6-series.
Function scope:
Activation of the ETU
Trip tests performed in the same ways as for the TD310
Gateway between PC and ETU
Parameterization of the ETUs with the powercon󹪝g software, the standard software for
parameterization and commissioning of all communication-capable SENTRON products (see
below)
Documentation and archiving of the parameters set on the ETU with the powercon󹪝g
software
Accessories
3.6Breaker Data Adapters and test devices
3VA27 molded case circuit breakers & 3WL10 air circuit breakers
Equipment Manual, 10/2023, L1V30499596002-03 125

Table of Contents

Other manuals for Siemens SENTRON 3WL10

Related product manuals