Siemens SENTRON 3WL10 - Mounting and Connecting the Device

Installing the guide frame
1. Install the guide frame in the switchboard panel:
Floor mounting (For the drilling template, see Chapter Switchboard panel, hole and drilling
templates, withdrawable breaker (Page226)):
– Fasten the guide frame to the base of the switchboard panel with four screws M8x25
(included in the scope of delivery) with a tightening torque of 21Nm.
Wall mounting (For the drilling template, see Chapter Switchboard panel, hole and drilling
templates, withdrawable breaker (Page226)):
Connection and commissioning
5.2Mounting and connecting the device
3VA27 molded case circuit breakers & 3WL10 air circuit breakers
Equipment Manual, 10/2023, L1V30499596002-03 165