Siemens SICAM TM User Manual

4 SICAM TM, Installation
Edition 10.2014, DC6-015-2.04
Notes on Safety
This manual does not constitute a complete catalog of all safety measures required for
operating the equipment (module, device) in question because special operating conditions
might require additional measures. However, it does contain notes that must be adhered to for
your own personal safety and to avoid damage to property. These notes are highlighted with a
warning triangle and different keywords indicating different degrees of danger.
Danger
means that death, serious bodily injury or considerable property damage will occur, if the appropriate
precautionary measures are not carried out.
Warning
means that death, serious bodily injury or considerable property damage can occur, if the appropriate
precautionary measures are not carried out.
Caution
means that minor bodily injury or property damage could occur, if the appropriate precautionary measures
are not carried out.
Hint
is important information about the product, the handling of the product or the respective part of the
documentation, to which special attention is to be given.
Qualified Personnel
Commissioning and operation of the equipment (module, device) described in this manual must be
performed by qualified personnel only. As used in the safety notes contained in this manual, qualified
personnel are those persons who are authorized to commission, release, ground, and tag devices,
systems, and electrical circuits in accordance with safety standards.
Use as Prescribed
The equipment (device, module) must not be used for any other purposes than those described in the
Catalog and the Technical Description. If it is used together with third-party devices and components,
these must be recommended or approved by Siemens.
Correct and safe operation of the product requires adequate transportation, storage, installation, and
mounting as well as appropriate use and maintenance.
During operation of electrical equipment, it is unavoidable that certain parts of this equipment will carry
dangerous voltages. Severe injury or damage to property can occur if the appropriate measures are not
taken:
· Before making any connections at all, ground the equipment at the PE terminal.
· Hazardous voltages can be present on all switching components connected to the power supply.
· Even after the supply voltage has been disconnected, hazardous voltages can still be present in the
equipment (capacitor storage).
· Equipment with current transformer circuits must not be operated while open.
· The limit values indicated in the manual or the operating instructions must not be exceeded; that also
applies to testing and commissioning.

Siemens SICAM TM Specifications

General

Brand	Siemens
Model	SICAM TM
Category	Controller
Language	English