Siemens SICAM TM User Manual

Table of Contents
SICAM TM, Installation 7
DC6-015-2.04, Edition 10.2014
8.5. Bus Interface Module CM-0842 ó Peripheral Control Module PE-6411, PE-
6412 ............................................................................................................... 80
8.6. Bus Interface Module CM-0842 ó Bus Interface Module CM-0843 ................ 81
9. Wiring Process Peripherals ........................................................................................ 83
9.1. Wiring Process Peripherals ............................................................................. 84
9.2. Peripheral Connector ...................................................................................... 85
9.3. TE-6450 – Wiring the Data Transmission ........................................................ 86
9.4. Wiring of analog measured values .................................................................. 88
10. Shielding / Protective Earthing ................................................................................... 89
10.1. Shielding ........................................................................................................ 90
10.2. Protective Earthing / Grounding ...................................................................... 91
11. Labelling ...................................................................................................................... 93
11.1. Introduction .................................................................................................... 94
11.2. Labeling Master Control Element .................................................................... 95
11.2.1. Equipment Identification, Region Number, Component Number ...................... 95
11.2.2. Plant- and Location Designation ..................................................................... 96
11.3. Labeling Peripheral Element ........................................................................... 97
11.3.1. Region Number, Component Number, PBA Number ....................................... 97
11.3.2. Plant- and Location Designation ..................................................................... 98
11.3.3. Equipment Identification (EI) ........................................................................... 99
11.4. Terminal Labeling ......................................................................................... 100
11.5. Individual Terminal Point Labeling ................................................................ 101
11.6. Terminal Coding ........................................................................................... 102
12. Parameter Setting Preparation ................................................................................. 103
12.1. Introduction .................................................................................................. 104
12.2. Physical connection between SICAM TOOLBOX II and SICAM TM .............. 104
12.2.1. Direct connection via toolbox cable ............................................................... 105
12.2.2. Serial via modem .......................................................................................... 106
12.2.3. Via Ethernet (TCP/IP) ................................................................................... 107
12.2.4. Via Ethernet (TCP/IP) and Terminal Server (serial) ....................................... 108
12.3. Logical Connection between SICAM TOOLBOX II and SICAM TM................ 109
12.4. Flash Card ................................................................................................... 110
12.4.1. Inserting Flash Card ..................................................................................... 111
12.4.2. Withdrawing Flash Card ............................................................................... 112
A. Recommended and tested purchased products ...................................................... 113
A.1. Modem ......................................................................................................... 114
A.2. DCF77 Accessories ...................................................................................... 115
A.3. GPS Satellite Receiver / Accessories............................................................ 116
A.4. LAN Time Server .......................................................................................... 117

Siemens SICAM TM Specifications

General

Brand	Siemens
Model	SICAM TM
Category	Controller
Language	English