Siemens SIMATIC 6DL1 136-6AA00-0PH1 - Page 25

Parameter Value range Default Re-parame‐
terization in
RUN
E󹪟ciency range
HART activated (Page 31)
• deactivated
• activated
Can only be con󹪝gured when the
"HART gate" is activated and the
measuring range "4..20mA" is set.
deactivated No Channel
Number HART message
frame repetitions
(Page 28)
0 to 10
Only relevant when the "HART ac‐
tivated" parameter is activated.
5 No Channel
Diagnostics HART
(Page 32)
• deactivated
• activated
Only relevant when the "HART ac‐
tivated" parameter is activated.
activated No Channel
Terminal block
Double-width terminal
block (Page 29)
• no
• yes
No No Module
Potential group
Potential group (Page 33)
• Potential group of the left
module (dark gray terminal
block)
• New potential group (light
gray terminal block)
• No potential group (black ter‐
minal block)
New potential group
(light gray terminal
block)
No Module
a
The F_source_address is automatically preset with the value "1" in S7 F/FH Systems and cannot
be changed in the properties of the I/O module.
b
The F_destination_address is automatically preset uniquely station-wide.
Note
Unused channels
"Disable" unused channels in the parameter assignment to improve the cycle time of the
module.
You can 󹪝nd more information on this in the section "Response times (Page 113)".
A deactivated channel always returns the analog value 0x0000 and QI = 0 ("Substitute value is
output").
Parameters/address space
5.3 Module/channel parameters
F-AI 8xI 2-/4-wire HART HA
Equipment Manual, 09/2021, A5E50557845-AA 25