Siemens SIMATIC ET 200S IM151-1 FO STANDARD - Prerequisites for Option Handling with RESERVE Modules

Functions
3.1 Option handling with RESERVE modules
IM151-1 FO STANDARD interface module (6ES7151-1AB05-0AB0)
16 Manual, 02/2010, A5E01075965-03
3.1.2 Prerequisites for option handling with RESERVE modules
Requirements
For option handling with RESERVE modules you require:
● An interface module that supports option handling with a RESERVE module.
● A power module PM-E 24 to 48 V DC (6ES7138-4CB50-0AB0 and higher) or PM-E 24 to
48 V DC/24 to 230 V AC (6ES7138-4CB10-0AB0 and higher).
Note
One of these power modules must be included in the configuration at least once, together
with one of the aforementioned interface modules.
● RESERVE modules as replacements for future electronic modules
● For configuration of the IM151-1 FO STANDARD
– DPV0/DPV1 mode: As of 09/2009 (V1.0 or higher), GSD file SI04806B.GSx
– DPV0 mode: GSD file SI02806B.GSx.
Note
In STEP 7, you do not require a GSD file for option handling with the:
 IM151-1 FO STANDARD as of STEP 7 V5.4.
 The current HW update for the interface and power modules. Use the menu
command "Options > Install HW Updates" in HW Config to link the HW update. The
HW updates can be downloaded from Customer Support on the Internet.
You can find the options handling description in the STEP 7 Online Help.
Note
If the actual configuration of an ET 200S station does not match the set configuration, a
diagnostics report is generated if the check for the relevant slots is not enabled for option
handling.