Siemens SIMATIC ET 200S IM151-1 FO STANDARD - 4 Error and System Messages; LED Displays on the Interface Module

IM151-1 FO STANDARD interface module (6ES7151-1AB05-0AB0)
Manual, 02/2010, A5E01075965-03
33
Error and system messages
4
4.1 LED displays on the interface module
LED display
1
2
3
6)
%)
21
(76
① Group error (red)
② Bus fault (red)
③ Supply voltage (green)
Status and error displays
Table 4- 1 Status and error messages of the IM151-1 FO STANDARD
Event (LEDs)
SF BF ON
Cause Remedy
Off Off Off There is no voltage at the interface module,
or the interface module has a hardware
defect.
Switch on the 24 V DC supply voltage at the
interface module.
* * On There is voltage at the interface module. ---
* Flashing On The interface module is not configured or is
configured incorrectly. No data exchange is
taking place between the DP master and the
interface module.
Causes:
 The PROFIBUS address is incorrect.
 Configuration error
 Parameter assignment error
 Check the interface module.
 Check the configuration and parameter
assignment.
 Check the PROFIBUS address.