Siemens SIMATIC ET 200S IM151-1 FO STANDARD - Table of Contents

IM151-1 FO STANDARD interface module (6ES7151-1AB05-0AB0)
Manual, 02/2010, A5E01075965-03
5
Table of contents
Preface ...................................................................................................................................................... 3
1
Properties
.................................................................................................................................................. 7
2 Pa
rameters.............................................................................................................................................. 11
2.1
Parameters for the IM151-1 FO STANDARD interface module
..................................................11
2.2
Parameter desc
ription..................................................................................................................12
2.2.1
DP interrupt mode.......................................................................................................
.................12
2.2.2 Bus length ..............................................................................................................
......................12
2.2.3 Enable startup for set <> actual configuration ..........................................................................
...12
2.2.4 Option handling in general..............................................................................................
.............12
2.2.5 Option handling: Slot 2 to 63 (with
RESERVE module) ..............................................................13
2.2.6 Diagnostic
interrupt ......................................................................................................................13
2.2.7 Process interrupt
..........................................................................................................................13
2.2.8 Inse
rt/remove-module interrupt....................................................................................................13
2.2.9 Analog-value
format.....................................................................................................................13
2.2.10 Interference frequenc
y suppression ............................................................................................13
2.2.11 Referenc
e junction slot ................................................................................................................14
2.2.12 Referenc
e junction input ..............................................................................................................14
3 Function
s................................................................................................................................................. 15
3.1
Option handling with RES
ERVE modules ...................................................................................15
3.1.1
Principle of operation of option handling
with RESERVE modules .............................................15
3.1.2 Prerequisites
for option handling with RESERVE modules.........................................................16
3.1.3 Example for using RESERVE modules
.......................................................................................17
3.1.4 Ass
igning parameters for option handling with RESERVE modules...........................................18
3.1.5 Controlling and monitoring options w
ith RESERVE modules......................................................19
3.1.6 Troubleshooting for option handli
ng with RESERVE modules....................................................21
3.1.7 Addres
s area for option handling and status byte with RESERVE modules...............................21
3.2 Option handling without RESERVE modules
..............................................................................23
3.2.1
Principle of o
peration of option handling without RESERVE modules ........................................23
3.2.2 Prerequisites
for option handling without RESERVE modules....................................................24
3.2.3 Example for use without RESERVE modules
..............................................................................25
3.2.4 Configuring option handling without RESERVE modules
............................................................26
3.2.5 Controlling and monitoring options w
ithout RESERVE modules.................................................27
3.3 Identification data
.........................................................................................................................29