Configuring
2.4 Configuration and Parameter Assignment
ET 200S Distributed I/O System - Fail-Safe Modules
26 Installation and Operating Manual, 08/2008, A5E00103686-07
2.4 Configuration and Parameter Assignment
Prerequisite
The requirements from chapter Using ET 200S Fail-Safe Modules (Page 14) apply to
configuring and assigning parameters for ET 200S fail-safe modules.
Configuration
Follow the usual procedure with
STEP 7 HW Config
to configure fail-safe modules (in the
same way as standard ET 200S modules).
Parameter Assignment for Module Properties
To assign parameters for fail-safe module properties, select the module in
STEP 7
HW Config
and select the menu command "Edit > Object Properties".
Parameters are downloaded from the programming device to the F-CPU, where they are
stored and then transferred to the fail-safe module.
Parameter Description
You will find a description of assignable fail-safe module parameters in this manual.
PROFIsafe Address and PROFIsafe Address Assignment
You can find a description of PROFIsafe addresses and the address assignment procedure
in this manual.
See also
Assignment of the PROFIsafe address (Page 29)
Parameters of the PM-E F pm DC24V PROFIsafe (Page 74)
Parameters of the PM-E F pp DC24V PROFIsafe (Page 90)
Parameters of the PM-D F DC24V PROFIsafe (Page 100)
Parameters of the EM 4/8 F-DI DC24V PROFIsafe (Page 108)
EM 4 F-DI/3 F-DO DC24V PROFIsafe parameters (Page 142)
Parameters for the EM 4 F-DO DC24V/2A PROFIsafe (Page 171)
To Next Page
Loading...
Need help?
General
