Siemens SIMATIC ET 200S Installation And Operating Manual

ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
9
Table of contents
Preface ......................................................................................................................................................
3
1 Product Overview ....................................................................................................................................
13
1.1 Introduction ..................................................................................................................................
13
1.2 ET 200S fail-safe modules...........................................................................................................
13
1.3 Using ET 200S Fail-Safe Modules...............................................................................................
14
1.4 Guide for Commissioning of ET 200S with Fail-Safe Modules....................................................
18
2 Configuring ..............................................................................................................................................
19
2.1 Configuring ET 200S with Fail-Safe Modules ..............................................................................
19
2.2 Assigning Modules of an ET 200S...............................................................................................
22
2.3 Maximum Number of Connectable Modules/Maximum Configuration ........................................
24
2.4 Configuration and Parameter Assignment...................................................................................
26
3 Address Assignment and Installation.......................................................................................................
27
3.1 Address assignments in the F-CPU.............................................................................................
27
3.2 Assignment of the PROFIsafe address .......................................................................................
29
3.3 Installing.......................................................................................................................................
31
4 Wiring and Fitting Modules ......................................................................................................................
33
4.1 Introduction ..................................................................................................................................
33
4.2 Safe Functional Extra Low Voltage for Fail-Safe Modules ..........................................................
33
4.3 Wiring fail-safe modules...............................................................................................................
34
4.4 Insertion and removal of fail-safe modules..................................................................................
36
4.5 Requirements for Sensors and Actuators....................................................................................
37
5 Diagnostics..............................................................................................................................................
41
5.1 Reactions to Faults ......................................................................................................................
41
5.2 Fault Diagnostics .........................................................................................................................
43
6 General Technical Specifications.............................................................................................................
49
6.1 Introduction ..................................................................................................................................
49
6.2 Standards and Approvals.............................................................................................................
49
6.3 Electromagnetic Compatibility......................................................................................................
53
6.4 Shipping and Storage Conditions ................................................................................................
57
6.5 Mechanical and Climatic Environmental Conditions....................................................................
57
6.6 Specifications for Nominal Line Voltages, Isolation Tests, Protection Class, and Type of
Protection.....................................................................................................................................
60

Siemens SIMATIC ET 200S Specifications

General

Brand	Siemens
Model	SIMATIC ET 200S
Category	I/O Systems
Language	English