Using the High_Speed_Counter technology object
3.5 Configuring the High_Speed_Counter
Counting, measurement and position detection
Function Manual, 12/2017, A5E32009889-AG
103
Note
For High_Speed_Counter as of V3.0, the following applies:
You can choose "Capture at signal N" only in operating mode "Use count value as
reference":
This parameter is used to define the frequency of the following events:
● Synchronization at signal N
● Synchronization as function of a digital input
You can select from the following options:
Once
The counter is only set at the first signal N or the first configured
edge of the digital input.
Periodic The counter is set at each signal N or each configured edge of the
To Next Page
Loading...
