Siemens SIMATIC ET 200SP - Module Versions; Module Version 2 I; 2 Q

Using the module
5.2 Using the digital input module
Counting, measurement and position detection
192 Function Manual, 12/2017, A5E32009889-AG
5.2
Using the digital input module
5.2.1
Configuring and assigning parameters to the module
5.2.1.1
Adding a module to the hardware configuration
Requirements
● The project has been created.
● The CPU has been created.
● The ET 200 distributed I/O has been created.
Procedure
1. Open the device configuration of the CPU or IM.
2. Select a module rack.
3. Select the digital input module from the module catalog:
"DI > Digital input module > Article number"
4. Drag the module to the required slot in the module rack.
Result
The new module is displayed under "Local modules" or "Distributed I/O" in the project tree.
5.2.1.2
Open hardware configuration
Opening via the project tree
Proceed as follows:
1. Open the "Local modules" or "Distributed I/O" folder in the project tree.
2. Double-click the module in the project tree.
Opening from the device view
Proceed as follows:
1. Open the device configuration of the CPU or IM.
2. Select the device view.
3. Click on the module.