Siemens SIMATIC ET 200SP - Accuracy Classes

Using the SSI_Absolute_Encoder technology object
4.2 Overview of the configuration steps
Counting, measurement and position detection
Function Manual, 12/2017, A5E32009889-AG
137
4.2
Overview of the configuration steps
Introduction
The overview below shows the basic procedure for configuring the position input and
measuring functions of the technology module with the SSI_Absolute_Encoder technology
object.
Requirement
Before you can use the technology object, a project with an S7-1500 CPU or an ET 200SP
CPU must be created in STEP 7 (TIA Portal).
Procedure
Proceed in the recommended sequence outlined below:
Step
Description
1
Configure a technology module (Page 169)
2 Add technology object (Page 138)
3
Configure a technology object according to your application (Page 140)
4
Call instruction in the user program (Page 157)
5
Load to CPU
6
Commissioning the technology object (Page 166)
7
Diagnostics of the technology object (Page 167)