The basics of counting, measurement and position detection
2.2 Basics of counting, measuring and position input (TM Count, TM PosInput, Compact CPU)
Counting, measurement and position detection
34 Function Manual, 12/2017, A5E32009889-AG
The figure below shows an example of the EN_CAPTURE and EVENT_CAP bits with use of
the Capture function by the rising edge at a digital input:
ured input filters delay the control signal of the corresponding digital input.
You can configure a hardware interrupt for the Capture function. Individual hardware
interrupts may be lost if the hardware interrupt rate is higher than the system
acknowledgement rate. You can signal a lost hardware interrupt with a diagnostic interrupt.
To Next Page
Loading...
