Siemens SIMATIC ET 200SP - Page 54

The basics of counting, measurement and position detection
2.2 Basics of counting, measuring and position input (TM Count, TM PosInput, Compact CPU)
Counting, measurement and position detection
Function Manual, 12/2017, A5E32009889-AG
53
Setting between comparison value 0 and comparison value 1
The comparison event can be configured for the digital output DQ1 if "Use by user program"
has been configured for the digital output DQ0.
DQ1 is set to 1 if:
Comparison value 0 <= measured value <= comparison value 1
Not setting between comparison value 0 and comparison value 1
The comparison event can be configured for the digital output DQ1 if "Use by user program"
has been configured for the digital output DQ0.
DQ1 is set to 1 if:
Comparison value 1 <= measured value <= comparison value 0