EasyManua.ls Logo

Siemens SIMATIC NET RX1500 - Page 152

Siemens SIMATIC NET RX1500
234 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cellular Modem Modules
6.5RUGGEDCOM RX1500PN LM W32
In any aircraft, whether in flight or on the ground (unless permitted by the
aircraft operator)
In such areas, the cellular modem must be disabled via host device’s operating
system. Otherwise the cellular modem can transmit signals that may interfere with
nearby equipment that is susceptible to radio interference.
WARNING
Communication disruption hazard – risk of serious personal injury, equipment
damage, or data loss
Wireless communications are susceptible to disruptions that may result in the delay,
corruption or loss of data. While cellular disruptions are uncommon when using a
Siemens cellular modem, avoid using the cellular modem in applications where a
communication failure could result in damage to equipment or personal injury to
persons in the area. Siemens accepts no responsibility for any damages that may
result due to wireless disruptions.
WARNING
Radiation hazard – risk of Radio Frequency (RF) exposure
The device must be placed at a distance of at least 20 cm (8 in) from all persons
during normal operation. The antennas used for this product must not be located
or operating in conjunction with any other antenna or transmitter, except in
accordance with FCC multi-transmitter evaluation procedures.
WARNING
Communication disruption hazard – risk of serious personal injury, equipment
damage, or data loss
Wireless communications are susceptible to disruptions that may result in the delay,
corruption or loss of data. While cellular disruptions are uncommon when using a
Siemens cellular modem, avoid using the cellular modem in applications where a
communication failure could result in damage to equipment or personal injury to
persons in the area. Siemens accepts no responsibility for any damages that may
result due to wireless disruptions.
Note
If the host device is intended for use in a portable device, separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.
Installation Requirements
The cellular modem module is approved for modular use in mobile applications. The
module, as part of the RUGGEDCOM RX1500, can be integrated into a final product
without additional certification from the Federal Communications Commission (FCC)
or Industry Canada (IC) if the application meets the following requirements:
RUGGEDCOM Modules
Catalog, 07/2021, C79000-G8976-1320-16
141

Table of Contents