Siemens SIMATIC PN/CAN LINK

New properties/functions
3.3 Installation and handling of the new HSP
SIMATIC PN/CAN LINK
Operating Instructions, 03/2022, A5E39895388-AC
19
3.3 Installation and handling of the new HSP
Installing HSP_V17_0358_001_Link_PN_CAN_V2.0
To work with firmware version V2.0 and the new functions, you must use the
HSP_V17_0358_001_Link_PN_CAN_V2.0. You can configure a PN/CAN LINK with firmware
version V1.0 using the same HSP.
If necessary, you can download and install the "HSP_V17_0358_001_Link_PN_CAN_V2.0"
from Siemens Industry Online Support.
You can find the Hardware Support Packages (HSP) as a download on the Internet
(https://support.industry.siemens.com/cs/us/en/view/72341852).
The HSP_V17_0358_001_Link_PN_CAN_V2.0 is only available for the TIA Portal version V17.
Figure 3-1 Selecting an HSP