Siemens SIMATIC PN/CAN LINK

Configuring/Programming
10.3 Configuring CAN transparent
SIMATIC PN/CAN LINK
Operating Instructions, 03/2022, A5E39895388-AC
129
10.3 Configuring CAN transparent
10.3.1 Overview
Configuring using HSP in the TIA Portal
The PN/CAN LINK is configured in the TIA Portal. The configuration for "CAN transparent"
operating mode mainly consists of the following steps:
1. Import PN/CAN LINK HSP into the TIA Portal.
2. Drag PN/CAN LINK from the HW catalog to the project.
3. Set the PROFINET-specific parameters.
4. Set the "CAN transparent" operating mode.
5. Set the transmission rate.
6. Set the transmit/receive messages and transmit/receive proxies.
7. Check and compile the configuration.