New properties/functions
3.3 Installation and handling of the new HSP
SIMATIC PN/CAN LINK
24 Operating Instructions, 03/2022, A5E39895388-AC
Figure 3-4 Change device
Notes for projects configured with TIA Portal V14 SP1
To use a PN/CAN LINK created in V14 SP1, follow these steps:
1. Click "Update module description". You must repeat this step for each individual PN/CAN
LINK. After clicking the "Update module description" button, the "Change firmware version"
button appears, and a message is shown at the bottom right stating that the PN/CAN LINK
was updated successfully. Now you can use the PN/CAN LINK with its OD entries and nodes
as needed.
To Next Page
Loading...
