Siemens SIMATIC SM 335 - Index

Index-1
SM 335 – High-Speed Analog Input/Output Module for the SIMATIC S7-300
6ES7 335-7HG00-8BA1
Index
Numbers
24-V-supply voltage, 2-10
A
ADU/DAU-fault, 3-36
Analog inputs
Connect, 2-3
Technical specifications, 1-7
Analog outputs
Connect, 2-5
Technical specifications, 1-10
B
Basic settings for inputs, Parameter block,
3-13
C
Common mode error, 3-38
Comparator. See Comparator mode
Comparator-check byte, 3-25, 5-12
Comparator mode, 5-3
Principle, 5-4
Comparator 1, 5-5
Comparator 2, 5-6
Conditional, Cycle Mode, 1-16
Conditional Cycle
See also Conditional Cycle Mode
Parameters for, 3-18
Connecting the SM 335, Principle, 2-2
Cycle time, for A/D conversion, 3-13
D
Default settings, 3-12
Diagnostic data, Format, 3-32
Diagnostic interrupt enable, 3-13
Diagnostics, 3-17
Diagnostics for inputs, Parameter block, 3-13
Diagnostics for outputs, Parameter block, 3-13
E
EEPROM-fault, 3-36
F
Faults, Troubleshooting, 6-8
Free Cycle
See also Free Cycle mode
Parameters for, 3-18
H
Hardware interrupt for end-of-cycle, 3-13
I
Interference suppression filter, 2-10
Interval counter
Determine speed, 4-9
Technical specifications, 1-11
Interval counter input
Connect, 2-6
Measuring principle, 4-3
Parameterize, 4-7
Values calculated, 4-8
M
Measurement, Parameter block, 3-13
Measuring Only. See Measuring Only Mode
Measuring Only mode, 5-14
Principle, 5-14
Switch to, 5-15
Measuring Range Module, 1-6
Measuring range overrange, 3-13
Measuring range underrange, 3-13
N
Number of pulses, 4-3