SIMODRIVE base line A Start-Up 2-1
2. Installation
2.1. Installation of SIMODRIVE base line A
Appearance check Please check the packaging prior to the installation of SIMODRIVE base
line A and make sure that the complete goods are delivered according to
the packing list. They should be complete and properly.
!
Warning
Observe the following sequence when mounting and dismounting the
equipment:
1. Make use of the original packaging during transportation;
2. Keep distance from the motion equipment while power is switching
on;
3. Disassembling should not be done only after the power has been
switched off for 30 minutes;
4. Cut off the line power supply of servo drive in case of the long-term
standstill of servomotor;
5. The protective grounding cable should be connected properly.
Mounting location SIMODRIVE base line A is of a compact design, so that the installation is
very simple. When fixing the servo drive in the cabinet, four (4) M6
screws are required.
It is recommended to adopt the vertical mounting in the cabinet.
A clearance of at least 100mm should be maintained between two servo
modules to ensure sufficient cooling space. For the top and bottom of
modules, clearances should be 100mm and 200mm respectively (see
Fig.2-1).
!
Caution
The environment requirements in the cabinet are as follows:
1. The permissible surroundings temperature of servo drive is 0~55°C,
but the power is to be de-rated if it is beyond 40°C;
2. The annual average of relative humidity is lower than 75%;
3. Vibration of cabinet is within 0.5G (4.9m/s
2
);
4. Condensation and icing should be avoided;
5. To guarantee the long-term stable work of servo drive, please keep
the surrounding temperature below 40°C.
To Next Page
Loading...
Need help?
General
