2.2 Motors used for the intended purpose
WARNING
Use not as intended
If you do not use the motors correctly, there is a risk of death, severe injury and/or material
damage.
• Only use the motors for their intended purpose.
• Do not use the motors in hazardous areas (where there is a risk of explosion), if the motors
have not been expressly released and authorized for these types of applications. Carefully
observe any special supplementary notes that may be attached.
• Make sure that the conditions at the location of use comply with all the rating plate data.
• Make sure that the conditions at the location of use comply with the conditions specied in
this documentation. When necessary, take into account deviations regarding approvals or
country-specic regulations.
WARNING
Malfunctions of active active implants due to magnetic and electrical elds
Electric motors endanger people with active implants, for example heart pacemakers, who
come close to the motors.
• If you are aected, stay a minimum distance of 30 cm away from the motors (tripping
threshold for static magnetic elds of 0.5 mT according to Directive 2013/35/EU).
Please contact your local Siemens oce in the following cases:
• If you wish to use special versions and design variants whose specications vary from the
motors described in this document.
• You have questions about the intended use.
The motor is intended for industrial or commercial plants.
The motor is designed for operation in sheltered areas under normal climatic conditions, such
as those found on shop oors.
For more detailed information, refer to Chapter "Ambient conditions (Page 27)".
The motor is only approved for operation through a converter.
Any other use of the motor is considered to be incorrect use.
Compliance with all specications in the operating instructions is part of correct usage.
Observe the details on the rating plate.
Description of the motors
2.2 Motors used for the intended purpose
1FK2 Synchronous Motors for SINAMICS S120
20 Conguration Manual, 02/2022, A5E46927724B AD
To Next Page
Loading...
Need help?
General