EasyManuals Logo

Siemens SIMOTICS SD User Manual

Siemens SIMOTICS SD
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
2.3 Quali󹪝ed personnel
All work at the machine must be carried out by quali󹪝ed personnel only. For the purpose of this
documentation, quali󹪝ed personnel is taken to mean people who ful󹪝ll the following
requirements:
Through appropriate training and experience, they are able to recognize and avoid risks and
potential dangers in their particular 󹪝eld of activity.
They have been instructed to carry out work on the machine by the appropriate person
responsible.
2.4 Safe handling
Workplace safety depends on the attentiveness, care, and common sense of the personnel who
install, operate, and maintain the machine. In addition to the safety measures cited, as a matter
of principle, the use of caution is necessary when you are near the machine. Always pay
attention to your safety.
Also observe the following to prevent accidents:
General safety regulations applicable in the country where the machine is deployed.
Manufacturer-speci󹪝c and application-speci󹪝c regulations
Special agreements made with the operator
Separate safety instructions supplied with the machine
Safety symbols and instructions on the machine and its packaging
Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum clearance and creepage distances may be
violated when coming close to live parts. Touching or coming close to them can result in death,
serious injury or material damage.
Ensure that all live parts are suitably covered.
Switch o󹪜 and disconnect the machine 󹪝rst if you want to remove covers. Observe the "5
safety rules".
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can result in death, serious injury or material
damage.
Ensure that all rotating parts are reliably covered.
Switch o󹪜 and disconnect the machine 󹪝rst if you want to remove covers. Observe the "5
safety rules".
Only remove covers when the rotating parts have come to a complete standstill.
Safety information
2.4Safe handling
1LE5, 1PC4 shaft heights 280 ... 355
20 Operating Instructions, 11/2022, A5E41454666A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTICS SD and is the answer not in the manual?

Siemens SIMOTICS SD Specifications

General IconGeneral
BrandSiemens
ModelSIMOTICS SD
CategoryEngine
LanguageEnglish

Related product manuals