Parameter List 09.02
5-38 Siemens AG 6SE7087-6AK85-1AA0
Rectifier/Regenerating Unit Operating Instructions
PNU
*
: Conf.
Par.
OP1S parameter name
Description
Value range
[phys. unit]
Selection text
Display
Indices
Factory-
setting
See
Modify
(access /
status)
5.16 Profile parameters
P917
*
Change Reports
Control word for spontaneous messages
If the value of an active parameter is changed, the new value is reported to
the programmable controller connected by means of the spontaneous
reporting mechanism. This function can be activated and de-activated for
each interface.
Important:
When the control word is modified, spontaneous message buffers can be
deleted with the loss of spontaneous messages!
0 No spontaneous messages
1 Output of spontaneous messages over the DPR interface
(TB/CB)
2 Output of spontaneous messages over the BASE SERIAL
interface (SST1)
4 Output of spontaneous messages over SCB with USS protocol
Setting help:
Each interface is coded with a number.
Enter the number and/or the sum of several numbers assigned to the
interfaces to enable the spontaneous message mechanism for the relevant
interface(s).
PNU=395Hex; Type=O2; Scaling: 1Hex
=
∧
1
0 to 7
inactive
TB/CB
SCom
SCB (USS)
-
0
3/ BR
3/ B
P918 CB Bus Address
Protocol depending bus address for communication board; see manual of
this board.
Notes:
The communication board checks, if the set value is valid. (Bus addresses 0
to 2 are reserved for master stations). If the value is not accepted, the fault
message 80 is issued with fault value 5
Condition:
P090=1 or P091=1 (communication board installed)
PNU=396Hex; Type=O2; Scaling: 1Hex
=
∧
1
0 to 200 -
3
3/ HBR
3/ H
P927
*
Parameter Access
Release of interfaces for the parameterization.
This parameter performs the same function as P053.
Parameter P053 can always be modified.
For description, see P053.
PNU=39FHex; Type=O2; Scaling: 1Hex
=
∧
1
0 to 31 -
6
3/ BR
3/ BR
P928
*
Src Base/Reserve
Source of the switching command 'base / reserve settings' (control word 2,
bit 30)
This parameter performs the same function as P590.
For description, see P590.
PNU=3A0Hex; Type=L2; Scaling: 1Hex
=
∧
1
0 to 6005 -
1005
3/ BR
3/ BR
AoteWell Automation Sales Team
Buy Siemens PLC HMI Drives at AoteWell.com
To Next Page
Loading...
