Siemens SINAMICS G120C User Manual

5.8.3 Changing parameter values
Overview
You can modify the settings of the converter by changing the parameter values in the converter.
Precondition
The converter only permits changes to write parameters. Write parameters begin with a "P", e.g.
P45.
The value of a read-only parameter cannot be changed. Read-only parameters begin with an
"r", for example: r2.
Function description
Procedure
1. Select the menu to display and change parameter values.
2.
2. Select the parameter 󹪝lter.
2.
– The converter only displays the most important parameters:
– The converter displays all of the parameters to you:
3. When the parameter number 󹪞ashes, select the desired parameter number.
2.
4. When the parameter value 󹪞ashes, change the parameter value.
2.
You changed a parameter value.
❒
Additional information
The converter immediately saves any changes so that they are protected against power failure.
Commissioning
5.8Handling the BOP 2 operator panel
SINAMICS G120C Converters
160 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating