Siemens SINAMICS G120C User Manual

5.8.5 Entering the parameter number directly
Overview
The BOP‑2 o󹪜ers the possibility of setting the parameter number digit by digit.
Precondition
You are in the menu for displaying and changing parameter values.
The number of a given parameter 󹪞ashes in the BOP-2 display.
Function description
Procedure
1. Press the OK button until the 󹪝rst digit of the parameter number 󹪞ashes.
V
2.
2. Change the parameter number digit-by-digit.
If you press the OK button, the BOP‑2 jumps to the next digit.
2.2.
3. After you have entered all of the digits of the parameter number, press the OK button.
You set the parameter number directly.
❒
Commissioning
5.8Handling the BOP 2 operator panel
SINAMICS G120C Converters
162 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating