Siemens SINAMICS G120C User Manual

Precondition
The converter power supply has been switched on.
A memory card is inserted in the converter.
Function description
Procedure
1. Select the upload.
2.2.
2. Set the number of your data backup. You can back up 99 di󹪜erent settings on the memory
card.
2.
3. Start the upload.
2.
4. Wait until the converter has backed up the settings to the memory card.
2.
You have backed up the settings of the converter to the memory card.
❒
6.2.6 Safely removing a memory card using the BOP-2
Function description
NOTICE
Data loss from improper handling of the memory card
If you remove the memory card when the converter is switched on without implementing the
"safe removal" function you may destroy the 󹪝le system on the memory card. The data on the
memory card are lost. The memory card will only function again after formatting.
• Only remove the memory card using the "safe removal" function.
Uploading the converter settings
6.2Uploading to the memory card
SINAMICS G120C Converters
170 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating