Siemens SINAMICS G120C User Manual

A.1.10 Firmware version 4.5
Table A-10 New functions and function changes in Firmware4.5
 Function SINAMICS
 G120 G120D
 
*&
&83
&8%
&8(
&8'
&8'
1 Support for the new Power Modules:
• PM230 IP20 FSA … FSF
• PM230 in a push-through FSA … FSC
- ✓ ✓ ✓ - -
2 Support for the new Power Modules:
• PM240-2 IP20 FSA
• PM240-2 in push-through FSA
- ✓ ✓ ✓ - -
3 New Control Units with PROFINET support ✓ ✓ - ✓ ✓ ✓
4 Support of the PROFIenergy pro󹪝le ✓ ✓ - ✓ ✓ ✓
5 Shared device support via PROFINET ✓ ✓ - ✓ ✓ ✓
6 Write protection ✓ ✓ ✓ ✓ ✓ ✓
7 Know-how protection ✓ ✓ ✓ ✓ ✓ ✓
8 Adding a second command data set (CDS0 → CDS0 … CDS1)
(All other converters have four command data sets)
✓ - - - - -
9 Position control and basic positioner - - - - - ✓
10 Support of an HTL encoder - - - - ✓ ✓
11 Support of an SSI encoder - - - - - ✓
12 Failsafe digital output - - - - ✓ ✓
A.2 Interconnecting signals in the converter
A.2.1 Fundamentals
The following functions are implemented in the converter:
• Open-loop and closed-loop control functions
• Communication functions
• Diagnosis and operating functions
Every function comprises one or several blocks that are interconnected with one another.
Appendix
A.2Interconnecting signals in the converter
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK 461

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating