Siemens SINAMICS G120C User Manual

5.5.5 Commissioning wizard
Select the application class
Procedure
When selecting an application class, the converter assigns the motor control with the
appropriate default settings:
• [1]
Standard Drive Control (Page144)
• [2] Dynamic Drive Control (Page146)
• [0] Expert - or if no application class is listed:
Expert (Page148)
Application class Standard Drive Control Dynamic Drive Control
Motors that can
be operated
Induction motors Induction and synchronous motors
Application exam‐
ples
• Pumps, fans, and compressors with 󹪞ow char‐
acteristic
• Wet or dry blasting technology
• Mills, mixers, kneaders, crushers, agitators
• Horizontal conveyor technology (conveyor
belts, roller conveyors, chain conveyors)
• Basic spindles
• Pumps and compressors with displacement ma‐
chines
• Rotary furnaces
• Extruder
• Centrifuges
Commissioning
5.5Quick commissioning with a PC.
SINAMICS G120C Converters
142 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating